74LS90 Decade Counter IC (7490 IC) DIP-14 Package

The  F280  is  a  high-speed  parity  generator/checker  that accepts  nine  bits  of  input  data  and  detects  whether  an even or an odd number of these inputs is HIGH. If an even number of inputs is HIGH, the Sum Even output is HIGH. I fan odd number is HIGH, the Sum Even output is LOW. The Sum Odd output is the complement of the Sum Even out-put

The 74F244 is an octal buffer that is ideal for driving bus lines of buffer memory address registers. The outputs are all capable of sinking 64mA and sourcing up to 15mA, producing very good capacitive drive characteristics. The device features two output enables, OEa and OEb, each controlling four of the 3-State outputs. The 74F244 is functionally equivalent to the 74F244. It has been designed to reduce effects of ground noise. Other advantages are noted in the features

Features :-

• Octal bus interface
• 3-State output buffer sink 64mA
• 15mA source current
• Guaranteed output skew less than 2.0ns (74F244B)
• Reduced ground bounce (74F244B)
• Reduced ICC (74F244B)
• Reduced loading (74F244B IIL = 40μA)
• Split lead frame offers increased noise immunity (74F244B)
• Industrial temperature range available (-40°C to +85°C) for 74F244
• 74F244 available in SSOP Type II package

The 74HC194/74HCT194 is a 4-bit bidirectional universal shift register. The synchronous operation of the device is determined by the mode select inputs (S0, S1). In parallel load mode (S0 and S1 HIGH) data appearing on the D0 to D3 inputs, when S0 and S1 are HIGH, is transferred to the Q0 to Q3 outputs. When S0 is HIGH and S1 is LOW data is entered serially via DSL and shifted from left to right; when S0 is LOW and S1 is HIGH data is entered serially via DSR and shifted from right to left. DSR and DSL allow multistage shift right or shift left data transfers without interfering with parallel load operation. If both S0 and S1 are LOW, existing data is retained in a hold mode. Mode select and data inputs are edge-triggered, responding only to the LOW-to-HIGH transition of the clock (CP). Therefore, the only timing restriction is that the mode control and selected data inputs must be stable one set-up time prior to the positive transition of the clock pulse. When LOW, the asynchronous master reset (MR) overrides all other input conditions and forces the Q outputs LOW. Inputs include clamp diodes. This enables the use of current limiting resistors to interface inputs to voltages in excess of VCC.

The 74F164 is an 8-bit edge-triggered shift register with serial data entry and an output from each of the eight stages. Data is entered through one of two inputs (Dsa, Dsb); either input can be used as an active High enable for data entry through the other input. Both inputs must be connected together or an unused input must be tied High. Data shifts one place to the right on each Low-to-High transition of the clock (CP) input, and enters into Q0 the logical AND of the two data inputs (Dsa, Dsb) that existed one setup time before the rising edge. A Low level on the Master Reset (MR) input overrides all other inputs and clears the register asynchronously, forcing all outputs Low.

Features :-

• Gated serial data inputs
• Typical shift frequency of 100MHz
• Asynchronous Master Reset
• Buffered clock and data inputs
• Fully synchronous data transfer
• Industrial temperature range available (–40 to +85 °C)