74LS243 3-State Quad Bus Transceiver IC (74243) DIP-14 Package

The  F280  is  a  high-speed  parity  generator/checker  that accepts  nine  bits  of  input  data  and  detects  whether  an even or an odd number of these inputs is HIGH. If an even number of inputs is HIGH, the Sum Even output is HIGH. I fan odd number is HIGH, the Sum Even output is LOW. The Sum Odd output is the complement of the Sum Even out-put

This device contains gates configured to perform a 4-2-3-2input AND-OR-INVERT function.

The 74HC163; 74HCT163 is a synchronous presettable binary counter with an internal look-head carry. Synchronous operation is provided by having all flip-flops clocked simultaneously on the positive-going edge of the clock (CP). The outputs (Q0 to Q3) of the counters may be preset to a HIGH or LOW. A LOW at the parallel enable input (PE) disables the counting action. It causes the data at the data inputs (D0 to D3) to be loaded into the counter on the positive-going edge of the clock. Preset takes place regardless of the levels at count enable inputs (CEP and CET). A LOW at the master reset input (MR) sets Q0 to Q3 LOW after the next positive-going transition on the clock input (CP). This action occurs regardless of the levels at input pins PE, CET and CEP. This synchronous reset feature enables the designer to modify the maximum count with only one external NAND gate. The look-ahead carry simplifies serial cascading of the counters. Both CEP and CET must be HIGH to count. The CET input is fed forward to enable the terminal count output (TC). The TC output thus enabled will produce a HIGH output pulse of a duration approximately equal to a HIGH output of Q0. This pulse can be used to enable the next cascaded stage. Inputs include clamp diodes. This enables the use of current limiting resistors to interface inputs to voltages in excess of VCC

Features :-

• Complies with JEDEC standard no. 7A
• Input levels:

For 74HC163: CMOS level For 74HCT163: TTL level

• Synchronous counting and loading
• 2 count enable inputs for n-bit cascading
• Synchronous reset
• Positive-edge triggered clock
• ESD protection:

HBM JESD22-A114F exceeds 2 000 V MM JESD22-A115-A exceeds 200 V

• Multiple package options
• Specified from -40 °C to +85 °C and -40 °C to +125 °C

The 74F244 is an octal buffer that is ideal for driving bus lines of buffer memory address registers. The outputs are all capable of sinking 64mA and sourcing up to 15mA, producing very good capacitive drive characteristics. The device features two output enables, OEa and OEb, each controlling four of the 3-State outputs. The 74F244 is functionally equivalent to the 74F244. It has been designed to reduce effects of ground noise. Other advantages are noted in the features

Features :-

• Octal bus interface
• 3-State output buffer sink 64mA
• 15mA source current
• Guaranteed output skew less than 2.0ns (74F244B)
• Reduced ground bounce (74F244B)
• Reduced ICC (74F244B)
• Reduced loading (74F244B IIL = 40μA)
• Split lead frame offers increased noise immunity (74F244B)
• Industrial temperature range available (-40°C to +85°C) for 74F244
• 74F244 available in SSOP Type II package